28 ga through 16 ga solid copper wire or 26-24 ga through 16 ga strand or bunched copper wire.
.321 to 1.291 mm dia solid copper wire, .129-.205 mm2 to 1.309 mm2 strand or bunched copper wire.

The Model BU-1 silver solder brazer from Micro Products Company is the easy, fast and accurate way to join fine gauge stranded copper conductor together. Simply place the two ends of the conductor to be joined into the special aligning dies. Insert the silver solder chip and push the operating button to automatically braze the ends together for a strong joint.

A super sensitive ball bearing headpiece and clamping mechanism insure proper alignment. The stepless braze voltage regulator, voltage meter and timer will give you the exact amount of heat needed every time in either the manual or automatic mode.
Unit of Measure

Capacity

N/A 28 ga through 16 ga solid copper wire or 26-24 ga through 16 ga strand or bunched copper wire
.321 to 1.291 mm dia solid copper wire, .129-.205 mm2 to 1.309 mm2 strand or bunched copper wire

Material Suitability

N/A Solid copper wire or mechanically stiff strand or bunched copper conductor

Standard Operating Voltage (AC)

N/A 110 to 120 V

Input Power Cycle

N/A 60 Hz

Line Demand

N/A 10 Amp

Single Phase Transformer

N/A 1.1 KVA

Weld Heat Selection

N/A Stepless weld heat selection

Clamp Method

N/A Spring assisted clamp fingers

Tension Method

N/A Adjustable spring

Mounting

N/A Suitable for bench or crane mounting or 4-wheel post type truck

Height Overall (Bench Type)

N/A 29 inches73.66 cm

Brazing Die Height (Bench Type)

N/A 18 inches45.72 cm

Floor or Bench Space (Bench Type)

N/A 11 x 18 inches27.94 x 45.72 cm

Weight (Bench Type)

N/A 70 lbs31.75 kg

Height Overall (Truck Type)

N/A 57 inches144.78 cm

Brazing Die Height (Truck Type)

N/A 46 inches116.84 cm

Floor or Bench Space (Truck Type)

N/A 24 x 24 inches60.96 x 60.96 cm

Weight (Truck Type)

N/A 120 lbs54.42 kg

N/A Joints are formed on strand or solid conductors by resistance heating the wire ends to a temperature sufficient to melt silver solder. A chip of silver solder is placed between wire ends, just enough contact pressure is applied to maintain intimate contact between faying surfaces. The operator may select either a manual or automatic mode.
Note: Materials must have enough mechanical compression strength, when heated to withstand slight contact pressures.

N/A

  • Micro-Weld quality and workmanship
  • Heavy-duty components & construction
  • Easy to operate controls
  • Low maintenance costs
  • Easy to set brazing adjustment parameters
  • Heavy-duty variable weld heat selection
  • Large faced weld voltage meter with safety shield
  • Manual or automatic mode selection switch
  • Heavy-duty braze timer
  • Rugged straight slide ball bearing equipped platens
  • Work lamp
  • Aligning dies with varying depth "V" grooves

N/A

  • Bench mounting
  • 4-wheel truck mounting
  • Special voltages
  • 50 hertz service
  • Export packing and crating
  • Hand swage tool
  • Silver solder materials